Subaru Impreza 2002 Service Manual page 424

NOTE:
The indicator is installed upside down compared to
the setting procedure of zero point. Add d1 [fixing
value: 55 mm (2.17 in)] from the following figure to
"D1", to obtain measurement value of "D1".
d1
M.SFT
Snap ring
T mm (in)
805072010
[t=1.65 mm
(0.065 in)]
64.12—64.42
32945AA021
(2.5244—
(None)
2.5362)
64.42—64.72
32945AA011
(2.5362—
(1)
2.5480)
64.72—65.02
32945AA001
(2.5480—
(3)
2.5598)
T = Thickness
4. SELECTION OF REVERSE FORK ROD
NOTE:
Perform the following procedures when:
• Replacing the reverse idler gear.
• Replacing the reverse idler gear No.2.
• Replacing the adapter plate.
• Replacing the base.
1) Insert the reverse idler gear assembly in adapter
plate.
SHIFTER FORK AND ROD
TR0861
Lot No. (Mark)
M.SFT M.SFT
Snap ring Snap ring
805072011 805072012
[t=1.95 mm [t=2.25 mm
(0.077 in)] (0.089 in)]
32945AA031 32945AA041
(2) (4)
32945AA021 32945AA031
(None) (2)
32945AA011 32945AA021
(1) (None)
6MT-129
MANUAL TRANSMISSION AND DIFFERENTIAL
2) Tighten the base COMPL fixing bolt.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
3) Set the height gauge to adapter plate. Lower the
indicator of height gauge to mating surface of
adapter plate and case, then set to zero point.
ST 18853AA000 HEIGHT GAUGE
NOTE:
• Remove the remaining gasket on edge surface
with scraper, since the adapter plate is base point
of measurement.
• Do not place the height gauge on shaded area in
the figure during measurement.
TR0725
TR0755
TR0756