Subaru Impreza 2002 Service Manual page 405

MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
1. DIFFERENTIAL CASE
1) Secure the differential assembly on a vise, then
remove the hypoid driven gear.
2) Drive out straight pin from the differential assem-
bly toward hypoid driven gear. (Without LSD)
ST 899904100 REMOVER
3) Pull out the pinion shaft, and remove the bevel
pinion gear and bevel gear and washer. (Without
LSD)
(D)
(A)
(A) Pinion shaft
(B) Bevel pinion gear
(C) Bevel gear
(D) Washer
FRONT DIFFERENTIAL ASSEMBLY
TR0822
G3M0667
(B)
(C)
(D)
(C)
(B)
TR0823
4) Using the ST, remove the hypoid driven gear
side bearing.
ST 399527700
5) Using a screw driver, make clearance of 2—3
mm (0.079—0.118 in) between the speedometer
drive gear and roller bearing.
NOTE:
Be careful not to damage the differential case.
(A) Speedometer drive gear
(B) Roller bearing
6) Using the ST, remove the roller bearing.
ST 498077000
6MT-110
PULLER SET
G3M0668
(A)
(B)
TR0824
REMOVER
ST
TR0825