Subaru Impreza 2002 Service Manual page 419

MANUAL TRANSMISSION AND DIFFERENTIAL
6) Shift the 1st-2nd sleeve to 2nd driven gear side,
then press down to the stopper and measure "B2".
(A) 2nd driven gear
(B) 1st-2nd sleeve
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 2nd side.
• Perform the measuring procedure with two peo-
ple, and measure the sleeve lifted up straight.
• Measure five points of the ball bearing turning
every approx. 72° apart. Round off each two upper
and lower measurement value. Use the remaining
center value as measurement value.
SHIFTER FORK AND ROD
(A)
(B)
TR0860
(2)
(1)
TR0758
6MT-124
7) According to both measurements, calculate the
1st-2nd sleeve neutral position. Select the fork rod
which applies to the calculated value from following
equation.
Equation: T = (B1 + B2) / 2
T : 1st-2nd sleeve center position
B1: Height from adapter plate edge to sleeve
edge when shifted to 1st gear.
B2: Height from adapter plate edge to sleeve
edge when shifted to 2nd gear. [measurement
value + 55 mm (2.17 in)]
NOTE:
The indicator is installed upside down compared to
the setting procedure of zero point. Add d1 [fixing
value: 55 mm (2.17 in)] from the following figure to
"B2", to obtain measurement value of "B2".
d1
T mm (in)
62.93 — 63.23
(2.4776 — 2.4894)
63.23 — 63.53
(2.4894 — 2.5012)
63.53 — 63.83
(2.5012 — 2.5130)
TR0861
Lot No. (Mark)
32801AA111 (1)
32801AA131 (None)
32801AA141 (2)