Subaru Impreza 2002 Service Manual page 336

13) Using the ST, install the spring pin of front drive
shaft.
ST 398791700 REMOVER
NOTE:
Align each chamfered part of front drive shaft and
axle drive shaft spring pin hole, and assemble
them. Then insert the spring pin.
14) Install the ball joint of transverse link to hous-
ing.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
15) Install the stabilizer nut.
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
NOTE:
Discard the loosened self-locking nut and replace
with a new one.
16) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
MANUAL TRANSMISSION ASSEMBLY
G2M0325
TR0642
TR0090
6MT-41
MANUAL TRANSMISSION AND DIFFERENTIAL
17) Install the center exhaust pipe. <Ref. to
EX(TURBO)-9, INSTALLATION, Center Exhaust
Pipe.>
18) Install the rear exhaust pipe and muffler. <Ref.
to EX(TURBO)-13, INSTALLATION, Rear Exhaust
Pipe.>, <Ref. to EX(TURBO)-12, INSTALLATION,
Joint Pipe.>
19) Install the universal joint. <Ref. to PS-27, IN-
STALLATION, Universal Joint.>
20) Install the under cover.
21) Install the intercooler assembly. <Ref. to
IN(TURBO)-11, INSTALLATION, Intercooler.>
22) Connect the battery ground cable to battery.