Subaru Impreza 2002 Service Manual page 397

MANUAL TRANSMISSION AND DIFFERENTIAL
3) Secure the ST on workbench.
ST 18664AA000 BASE
4) Lift the caulking of lock nut.
5) Install the ST3 to lock nut, then set drive pinion
shaft to ST. Remove the lock nut and washer.
ST1 18667AA000 HOLDER
ST2 18664AA000 BASE
ST3 18621AA000 ADAPTER WRENCH
6) Using the ST, remove the taper roller bearing as-
sembly.
ST 18723AA000 REMOVER
D: ASSEMBLY
1) Using the ST, measure dimension A of drive pin-
ion.
NOTE:
Note dimension A for selection of drive pinion shim.
ST 398643600 GAUGE
DRIVE PINION SHAFT ASSEMBLY
TR0810
TR0811
B3M1176A
6MT-102
2) Install the inner bearing inner race to drive pinion
shaft using ST and press.
ST 18723AA000 REMOVER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 lmp ton).
3) Install the retainer and outer bearing inner race
to drive pinion shaft using ST and press.
ST 18723AA000 REMOVER
NOTE:
Press to the point where bearing is turned smoothly
without slack.
(A)
(A) Retainer
4) Install the washer and new lock nut.
TR0812
TR0813