Subaru Impreza 2002 Service Manual page 917

MECHANICAL
(5) Install the front side V-belt, and adjust it.
<Ref. to ME-44, FRONT SIDE BELT, INSTAL-
LATION, V-belt.>
(6) Install the resonator chamber.
Tightening torque:
33 N·m (3.4 kgf-m, 24.6 ft-lb)
11) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
12) Tighten the nuts which install front cushion rub-
ber onto crossmember.
Tightening torque:
85 N·m (8.7 kgf-m, 63 ft-lb)
CAUTION:
Make sure the front cushion rubber mounting
bolts (A) and locator (B) are securely installed.
ENGINE ASSEMBLY
13) Install the front and center exhaust pipe.
<Ref. to EX-8, INSTALLATION, Front Exhaust
Pipe.> and <Ref. to EX(w/oOBD)-10, INSTALLA-
TION, Front Exhaust Pipe.>
14) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
15) Connect the following connectors.
(1) Engine ground cables
Tightening torque:
14 N·m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connectors
B6M1237
(5) Power steering pressure switch
16) Connect the following cables.
(1) Accelerator cable
(2) Cruise control cables (With cruise control)
CAUTION:
After connecting each cable, adjust them.
17) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
18) Install the A/C pressure hoses.
<Ref. to AC-37, INSTALLATION, Hose and Tube.>
NOTE:
Use new O-rings.
Tightening torque:
B3M2047
25 N·m (2.5 kgf-m, 18.1 ft-lb)
19) Install the radiator to vehicle. <Ref. to CO-42,
INSTALLATION, Radiator.>
20) Install the air intake duct and air cleaner case.
<Ref. to IN-7, INSTALLATION, Air Intake Duct.>
and <Ref. to IN-6, INSTALLATION, Air Cleaner
Case.>
21) Install the under cover.
B2M3880A
22) Install battery in the vehicle, and then connect
the cables.
ME-40
B2M3385