Subaru Impreza 2002 Service Manual page 423

MANUAL TRANSMISSION AND DIFFERENTIAL
(1) Shift the 5th-6th sleeve to 6th main gear
side, then press down to the stopper and mea-
sure "D2".
(A) 6th main gear
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 6th side.
• Perform the measuring procedure with two peo-
ple, and measure the sleeve lifted up straight.
• Measure five points of the ball bearing turning
every approx. 72°. Round off each two upper and
lower measurement value. Use the remaining cen-
ter value as measurement value.
(2) Set the height gauge indicator upside down.
(A)
(A) Indicator
SHIFTER FORK AND ROD
(A)
TR0868
(2)
(1)
TR0758
TR0865
6MT-128
(3) Shift the 5th-6th sleeve to 5th main gear
side, then press down to the stopper and mea-
sure "D2".
(A) 5th main gear
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 5th side.
• Measure five points of the ball bearing turning
every approx. 72°. Round off each two upper and
lower measurement value. Use the remaining cen-
ter value as measurement value.
4) According to both measurements, calculate the
5th-6th sleeve neutral position. Select the fork rod,
which applies to the calculated value from following
equation.
Equation: T = (D1 + D2) / 2
T : 5th-6th sleeve center position
D1: Length from the shaft rear bearing snap ring
groove to sleeve groove edge when shifted to
5th gear. [measurement value + 55 mm (2.17
in)]
D2: Length from main shaft rear bearing snap
ring groove to sleeve groove edge when shift-
ed to 6th gear.
(A)
TR0869
(2)
(1)
TR0758