Subaru Impreza 2002 Service Manual page 938

(6) Tighten the bolts (o) through (v) in alphabet-
ical sequence.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
(7) Tighten the bolts (w) through (x) in alphabet-
ical sequence.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
3) Apply a coat of grease to oil seal lips, and then
install the oil seal (A) on camshaft using ST1 and
ST2.
NOTE:
Use a new oil seal.
ST1 499597000 OIL SEAL GUIDE
ST2 499587500 OIL SEAL INSTALLER
4) Install the plug using ST.
ST 499587700 CAMSHAFT OIL SEAL IN-
STALLER
5) Adjust the valve clearance. <Ref. to ME-32, AD-
JUSTMENT, Valve Clearance.>
CAMSHAFT
6) Install the rocker cover and connect PCV hose.
7) Install the oil level gauge guide. (LH side only)
8) Install the camshaft position sensor support. (LH
side only)
9) Install the tensioner bracket.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
B2M2621D
10) Install the belt cover No. 2 (RH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
11) Install the belt cover No. 2 (LH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
B2M2621E
12) Install the crankshaft sprocket. <Ref. to ME-56,
INSTALLATION, Crankshaft Sprocket.>
13) Install the camshaft sprocket. <Ref. to ME-54,
INSTALLATION, Camshaft Sprocket.>
14) Install the timing belt assembly. <Ref. to ME-
50, INSTALLATION, Timing Belt Assembly.>
15) Install the belt cover. <Ref. to ME-48, INSTAL-
LATION, Belt Cover.>
16) Install the crankshaft pulley. <Ref. to ME-46,
INSTALLATION, Crankshaft Pulley.>
17) Install the V-belt. <Ref. to ME-44, INSTALLA-
TION, V-belt.>
S2M1864A
ME-61
MECHANICAL
H2M2380
B2M2601