Subaru Impreza 2002 Service Manual page 371

MANUAL TRANSMISSION AND DIFFERENTIAL
11) Install the checking ball, checking spring, new
gasket and checking plug.
Tightening torque:
37 N·m (3.8 kgf-m, 27.3 ft-lb)
(A) Checking plug
(B) Gasket
(C) Checking spring
(D) Checking ball
12) Install the bolt and new gasket.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
13) Using a screwdriver, shift to 4th gear position.
MAIN SHAFT ASSEMBLY
(A)
(B)
(C)
(D)
TR0728
TR0725
6MT-76
14) Install the reverse idler holder
(A)
(A) Reverse idler holder
15) Install the striking rod.
16) Install the transmission case. <Ref. to 6MT-69,
INSTALLATION, Transmission Case.>
17) Install the selected main shaft snap ring and
washer.
18) Install the oil pump. <Ref. to 6MT-65, INSTAL-
LATION, Oil Pump.>
19) Install the center differential. <Ref. to 6MT-62,
INSTALLATION, Center Differential.>
20) Install the transfer driven gear. <Ref. to 6MT-
60, INSTALLATION, Transfer Driven Gear.>
21) Install the extension case. <Ref. to 6MT-49, IN-
STALLATION, Extension Case.>
22) Install the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-44,
INSTALLATION, Oil Pipe.>, <Ref. to 6MT-47, IN-
STALLATION, Neutral Position Switch.>, <Ref. to
6MT-45, INSTALLATION, Back-up Light Switch.>
23) Install the manual transmission assembly to ve-
hicle. <Ref. to 6MT-39, INSTALLATION, Manual
Transmission Assembly.>
C: DISASSEMBLY
NOTE:
Each sleeve and hub engage at a specified point.
Mark an engagement point on the sleeve and hub
before disassembly.
1) Secure the ST on workbench.
ST 18664AA000 BASE
2) Lift the caulking of lock nut.
TR0723