Subaru Impreza 2002 Service Manual page 384

8) Remove the outer baulk ring, 2nd synchro cone
and inner baulk ring.
(A) Outer baulk ring
(B) 2nd synchro cone
(C) Inner baulk ring
9) Using the ST, remove each parts.
ST 18754AA000 REMOVER
(E)
(A) 2nd bush
(B) 1st-2nd hub
(C) Outer baulk ring
(D) 1st synchro cone
(E) Inner baulk ring
(F) 1st driven gear
(G) 1st needle bearing
DRIVEN GEAR ASSEMBLY
D: ASSEMBLY
NOTE:
Replace the following parts as a set:
• Sleeve and hub
• Outer baulk ring, 1st synchro cone, inner baulk
(C)
ring
(B)
• Outer baulk ring, 2nd synchro cone, inner baulk
(A)
ring
1) Sufficiently apply gear oil to the drive shaft, 1st
needle bearing and inner periphery of 1st driven
gear.
2) Install the 1st needle bearing.
TR0766
3) Install the 1st driven gear to driven shaft.
(A)
(B)
(C)
4) Install the inner baulk ring.
(D)
(F)
(G)
TR0767
6MT-89
MANUAL TRANSMISSION AND DIFFERENTIAL
TR0768
TR0769
TR0770