Subaru Impreza 2002 Service Manual page 282

8. 6MT Gear Shift Lever
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the gear shift knob.
4) Remove the console box front. <Ref. to EI-40,
REMOVAL, Console Box.>
5) Remove the boot plate from body.
6) Lift-up the vehicle.
7) Remove the under cover.
8) Remove the rear exhaust pipe and muffer. <Ref
to EX(TURBO)-13, REMOVAL, Rear Exhaust
Pipe.>, <Ref to EX(TURBO)-14, REMOVAL,
Muffer.>
9) Remove the crossmember. <Ref. to 6MT-35,
REMOVAL, Transmission Mounting System.>
10) Remove the snap pin and washer, and then re-
move the reverse check cable from reverse check
lever.
(B)
(A) Snap pin
(B) Washer
(C) Reverse check cable
6MT GEAR SHIFT LEVER
TR0953
(A)
(C)
TR0954
CS-5
11) Move the transmission to right side, and then
remove the joint COMPL, stay bolt and reverse
check cable.
NOTE:
If the transmission is not moved, the joint COMPL
and stay bolt will contact body and damage may
occur.
(C)
(A)
(B)
(A) Joint COMPL bolt
(B) Stay bolt
(C) Reverse check cable
12) Remove the cushion rubber from body.
13) Lower the vehicle.
14) Remove the gear shift lever.
CONTROL SYSTEMS
TR0955
TR0956