Subaru Impreza 2002 Service Manual page 291

CONTROL SYSTEMS
12) Move the transmission to right side, and then
remove the stay bolt and reverse check cable.
NOTE:
If the transmission is not moved, stay bolt will con-
tact body and damage may occur.
(A)
(B)
(A) Stay
(B) Stay bolt
13) Raise the clip of stay, and then separate the
stay and reverse check cable.
(A)
(A) Reverse check cable
(B) Clip
14) Remove the reverse check cable by pulling
from underneath the vehicle.
NOTE:
Take care not to damage the inner boot.
REVERSE CHECK CABLE
TR0976
(B)
TR0974
15) Loosen the lock nut, then remove the reverse
check cable from cable plate.
(A) Cable plate
(B) Reverse check cable
B: INSTALLATION
1) Adjust the length between end of cable plate and
reverse check cable to 84 mm (3.31 in), and then
tighten the lock nut.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
(A) 84 mm (3.31 in)
2) Insert the reverse check cable to the hole of in-
ner boots from underneath the vehicle.
3) Move the transmission to right side, and then in-
stall the stay.
Tightening torque:
T: 32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A)
T
(A) Stay
CS-14
(B)
(A)
(A)
TR0961
TR0973
TR0977