Subaru Impreza 2002 Service Manual page 522

DIAGNOSTICS CHART WITH SUBARU SELECT MONITOR
Step
2 CHECK POOR CONTACT IN CONNECTORS. Is there poor contact in con-
3 CHECK ABSCM&H/U.
1)Connect all connectors.
2)Erase the memory.
3)Perform the inspection mode.
4)Read out the DTC.
4 CHECK ANY OTHER DIAGNOSTIC TROU-
BLE CODES (DTCs) APPEARANCE.
5 CHECK FREEZE FRAME DATA.
1)Select "Freeze frame data" on the select
monitor.
2)Read front right wheel speed on the select
monitor display.
6 CHECK FREEZE FRAME DATA.
Read front left wheel speed on the select mon-
itor display.
7 CHECK FREEZE FRAME DATA.
Read rear right wheel speed on the select
monitor display.
8 CHECK FREEZE FRAME DATA.
Read rear left wheel speed on the select moni-
tor display.
9 CHECK FREEZE FRAME DATA.
Read lateral G sensor output on the select
monitor display.
10 CHECK OPEN CIRCUIT IN LATERAL G SEN-
SOR OUTPUT HARNESS AND GROUND
HARNESS.
1)Turn the ignition switch to OFF.
2)Disconnect the connector from ABSCM&
H/U.
3)Measure the resistance between
ABSCM&H/U connector terminals.
Connector & terminal
LHD: (B301) No. 29 — No. 28:
RHD: (F49) No. 29 — No. 28:
11 CHECK BATTERY SHORT OF HARNESS.
1)Turn the ignition switch to OFF.
2)Remove the console box.
3)Disconnect the connector from lateral G sen-
sor.
4)Disconnect the connector from ABSCM&
H/U.
5)Measure the voltage between ABSCM&H/U
connector and chassis ground.
Connector & terminal
LHD: (B301) No. 29 (+) — Chassis
ground ( − − − − ):
RHD: (F49) No. 29 (+) — Chassis ground
( − − − − ):
Check
nector between ABSCM&H/U
and lateral G sensor?
Is the same DTC as in current
diagnosis still being output?
Are other DTCs being output? Proceed with the
Is the front right wheel speed
on monitor display 0 km?
Is the front left wheel speed on
monitor display 0 km?
Is the rear right wheel speed
on monitor display 0 km?
Is the rear left wheel speed on
monitor display 0 km?
Is the lateral G sensor output
on monitor display more than
3.65 V?
Is the resistance between 5.0
and 5.6 kΩ?
Is the voltage less than 1 V?
ABS-25
ABS (DIAGNOSTICS)
Yes
Repair the con- Go to step 3.
nector.
Replace the Go to step 4.
ABSCM&H/U.
<Ref. to ABS-4,
ABS Control Mod-
ule and Hydraulic
Control Unit
(ABSCM&H/U).>
A temporary poor
diagnosis corre- contact.
sponding to DTC.
Go to step 6. Go to step 16.
Go to step 7. Go to step 16.
Go to step 8. Go to step 16.
Go to step 9. Go to step 16.
Go to step 10. Go to step 16.
Go to step 11. Repair the har-
ness/connector
between lateral G
sensor and
ABSCM&H/U.
Go to step 12. Repair the har-
ness between lat-
eral G sensor and
ABSCM&H/U.
No