Subaru Impreza 2002 Service Manual page 178

(5) Install the front side V-belt, and adjust it.
<Ref. to ME-44, FRONT SIDE BELT, INSTAL-
LATION, V-belt.>
12) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
13) Tighten the nuts which install front cushion rub-
ber onto crossmember.
Tightening torque:
85 N·m (8.7 kgf-m, 62.7 ft-lb)
CAUTION:
Make sure the front cushion rubber mounting
bolts (A) and locator (B) are securely installed.
14) Install the center exhaust pipe. <Ref. to
EX(TURBO)-9, INSTALLATION, Center Exhaust
Pipe.>
15) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
16) Connect the following connectors and termi-
nals.
(1) Engine ground terminal
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connectors (With A/C)
ENGINE ASSEMBLY
17) Connect the following cables.
(1) Accelerator cable
(2) Clutch release spring
CAUTION:
After connecting each cable, adjust them.
18) Install the air intake system.
(1) Install the intercooler. <Ref. to IN(TURBO)-
11, INSTALLATION, Intercooler.>
(2) Install the air cleaner element and air clean-
er upper cover.
(3) Install the engine harness connector brack-
et.
(4) Install the filler hose to air cleaner case.
B2M2790
19) Install the A/C pressure hoses. (With A/C)
CAUTION:
Use new O-rings.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
B2M3880A
20) Install the radiator. <Ref. to CO-42, INSTALLA-
TION, Radiator.>
21) Install the coolant filler tank. <Ref. to CO-53,
INSTALLATION, Coolant Filler Tank.>
22) Install the window washer tank.
23) Install the battery in vehicle, and connect the
cables.
24) Fill coolant. <Ref. to CO-26, FILLING OF EN-
GINE COOLANT, REPLACEMENT, Engine Cool-
ant.>
ME(STi)-39
(A) Filler hose
(B) Connector bracket
MECHANICAL
H2M1962B
S2M1584