NOTE:
• Install the lock wire to stay groove.
• Bend the extra wire to same direction of lock wire
winding.
(A)
B
(B)
B - B
(A) Inner boot
(B) Wire
(C) Stay
11) Install the holder.
Tightening torque:
1.3 N·m (0.13 kgf-m, 0.96 ft-lb)
(A) Holder
12) Insert the reverse check cable into boot hole.
6MT GEAR SHIFT LEVER
(A)
B
(B)
(C)
(B)
TR0971
(A)
TR0963
13) Insert the reverse check cable into gear shift
assembly, and fix with band clip.
NOTE:
• Cut off the extra band clip.
• Make sure that the reverse check cable is insert-
ed into gear shift lever assembly without any clear-
ance.
14) Install the spring seat and spring.
(A) Spring
(B) Spring seat
15) Adjust the length between end of cable plate
and reverse check cable to 84 mm (3.31 in), and
then tighten the lock nut.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
(A) 84 mm (3.31 in)
CS-11
CONTROL SYSTEMS
TR0960
(A)
(B)
TR0972
(A)
TR0973