Subaru Impreza 2002 Service Manual page 388

21) Using the ST, install the 5th-6th driven gear.
ST 18654AA000 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 lmp ton).
NOTE:
• Make sure to install the 5th-6th driven gear in
proper direction.
• Align the groove of 5th-6th driven gear with key.
ST
(B)
(A) 6th gear
(B) 5th gear
(C) 4th gear
22) Using the ST, install the ball bearing.
ST 18654AA000 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 lmp ton).
NOTE:
Make sure to install the ball bearing in proper direc-
tion.
ST
23) Make sure the ball bearing is smoothly turned
by hand. If not, reassemble.
24) Install a new lock nut.
DRIVEN GEAR ASSEMBLY
25) Install the ST3 to lock nut, then install the ST to
driven gear assembly and tighten lock nut.
ST1 18666AA000 HOLDER
ST2 18664AA000 BASE
ST3 18620AA000 ADAPTER WRENCH
ST4 18852AA000 TORQUE WRENCH
Tightening torque:
(A)
(C)
TR0783
NOTE:
If torque wrench except ST4 is used, calculate the
following equation, then tighten the lock nut.
T=L1/(0.1 + L1)×570
T
L1
0.1 m (3.94 in)
570 N·m (58.1 kgf-m, 420 ft-lb)
TR0784
6MT-93
MANUAL TRANSMISSION AND DIFFERENTIAL
530 N·m (54.0 kgf-m, 391 ft-lb)
N·m (kgf-m, ft-lb) Setting value of torque
m (in) Torque wrench length
(A)
(A) 0.1 m (3.94 in)
TR0785
wrench
ST length
Tightening torque of lock
nut
L1
TR0786