12.V-belt
A: REMOVAL
1. FRONT SIDE BELT
NOTE:
Perform the following procedures 1) to 4) with the
engine installed to the body.
1) Remove the V-belt cover.
2) Loosen the lock bolt (A).
3) Loosen the slider bolt (B).
4) Remove the front side belt (C).
(B)
2. REAR SIDE BELT
1) Loosen the lock nut (A).
2) Loosen the slider bolt (B).
3) Remove the rear side belt.
V-BELT
EN0048
(C)
(A)
EN0225
(B)
(A)
EN0226
ME(STi)-43
4) Remove the rear side belt tensioner.
B: INSTALLATION
1. FRONT SIDE BELT
CAUTION:
Wipe off any oil or water on the belt and pulley.
1) Install the front side belt (C), and tighten the slid-
er bolt so as to obtain the specified belt tension
<Ref. to ME(STi)-44, INSPECTION, V-belt.>
2) Tighten the lock bolt (A)
3) Tighten slider bolt (B).
Tightening torque:
Lock bolt through bolt:
25 N·m (2.5 kgf-m, 18 ft-lb)
Slider bolt:
8 N·m (0.8 kgf-m, 5.5 ft-lb)
(B)
MECHANICAL
S2M0113
(C)
(A)
EN0225