Subaru Impreza 2002 Service Manual page 335

MANUAL TRANSMISSION AND DIFFERENTIAL
6) Make sure the release bearing is installed com-
pletely.
NOTE:
• Push the release fork to operating cylinder side
until you hear a "click" sound. Pull the release fork
to engine side. Setting is completed if the release
fork does not contact case.
• Make sure the boot cover is firmly set.
7) Install the pitching stopper bracket, and then in-
stall the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
8) Install the clutch operating cylinder.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
NOTE:
Check that the clutch hose is routed properly.
MANUAL TRANSMISSION ASSEMBLY
H2M1818
TR0086
TR0640
6MT-40
9) Install the starter assembly.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
10) Install the transmission and body ground cable.
11) Connect the connector located on the upper
side of transmission.
(A) Vehicle speed sensor connector
(B) Transmission connector
12) Lift-up the vehicle and install the drive shaft.
TR0638
TR0639
(A)
(B)
TR0637