Subaru Impreza 2002 Service Manual page 470

17) Install the crown gear on differential case.
NOTE:
Before installing the bolts, apply Lock Tite to bolt
threads.
Lock Tite:
THREE BOND 1324 or equivalent
NOTE:
Tighten diagonally while tapping the bolt heads.
Tightening torque:
105 N·m (10.7 kgf-m, 77.4 ft-lb)
18) Press-fit the side bearing cone onto differential
case with ST.
ST 398487700 DRIFT
19) Assembling side retainer.
(1) Press-fit the side bearing outer race with
press and ST.
ST 398417700 DRIFT
ST
(2) Install the oil seal. <Ref. to DI-58, RE-
PLACEMENT, Rear Differential Side Oil Seal.>
REAR DIFFERENTIAL FOR T-TYPE
S3M0509
G3M0091
DR0038
DI-27
20) Adjusting side bearing retainer shims
(1) The driven gear backlash and side bearing
preload can be determined by the side bearing
retainer shim thickness.
(2) Install the differential case assembly into dif-
ferential carrier in the reverse order of disas-
sembly.
(3) Install the side retainer shims and O-rings to
the right and left retainers from which they were
removed.
NOTE:
• Replace the broken or cracked O-ring with new
one.
• Replace the broken or corroded side retainer
shim with a new one of same thickness.
Side bearing retainer shim
Part No.
383475201
383475202
383475203
383475204
383475205
(4) Align the arrow mark on differential carrier
with the mark on side retainer during installation.
NOTE:
Be careful that side bearing outer race is not dam-
aged by bearing roller.
(A) Arrow mark
DIFFERENTIALS
S3M0533
Thickness mm (in)
0.20 (0.0079)
0.25 (0.0098)
0.30 (0.0118)
0.40 (0.0157)
0.50 (0.0197)
S3M0172B