Subaru Impreza 2002 Service Manual page 916

6) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
7) Remove the ST from torque converter clutch
case. (AT model)
NOTE:
Be careful not to drop the ST into torque converter
clutch case when removing ST.
ST 498277200 STOPPER SET
8) Install the starter. <Ref. to SC-6, INSTALLA-
TION, Starter.>
9) Install the torque converter clutch onto drive
plate. (AT model)
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using ST.
CAUTION:
Be careful not to drop the bolts into torque con-
verter clutch housing.
ST 499977300 CRANK PULLEY WRENCH
(1600 cc and 2000 cc model)
ST 499977100 CRANK PULLEY WRENCH
(2500 cc model)
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog the plug onto service hole.
ENGINE ASSEMBLY
10) Install the power steering pump on bracket.
(1) Install the power steering tank on bracket.
(2) Install the power steering pump on bracket,
and then tighten the bolts.
H3M1839A
Tightening torque:
20.1 N·m (2.05 kgf-m, 14.8 ft-lb)
(3) Tighten the bolts which install power steer-
ing pump bracket, and then install the spark plug
cords.
(4) Connect the power steering switch connec-
tor.
S2M0207
ME-39
MECHANICAL
EN0361
B2M3151A
B2M4126
EN0360