Subaru Impreza 2002 Service Manual page 734

20.KEYLESS ENTRY SYSTEM
Check the keyless entry system operations as fol-
lows.
• Remove the key from the ignition switch and
close all the doors including rear gate (wagon).
• Press the "LOCK" button on the transmitter mo-
mentarily once and check if all the doors are locked
and the hazard light flashes once.
• Press the "OPEN" button on the transmitter mo-
mentarily once and check if all doors are unlocked,
the hazard light flashes twice and the dome light il-
luminates.
• Close all doors and rear gate, press the "LOCK"
button of the transmitter. Press the "OPEN" button
of the transmitter and wait for 30 seconds. Check
that all doors and the rear gate are automatically
locked again.
21.SEAT
Check that each seat provides full functionality in
sliding and reclining. Check all available functions
of the rear seat such as a trunk-through center arm
rest.
22.SEAT BELT
Pull out the seat belt and then release it. Check that
the belt webbing retracts smoothly.
23.WHEEL ALIGNMENT
Check the wheel alignments. <Ref. to FS-8, Wheel
Alignment.> and <Ref. to RS-9, Wheel Alignment.>
PRE-DELIVERY INSPECTION
B5M1182
PI-9
PRE-DELIVERY INSPECTION
24.READ MEMORY AND TEST MODE CON-
NECTORS
Turn the ignition switch to ON and check that the
check-engine light starts blinking. If the light blinks,
return the ignition key to LOCK and disconnect the
test mode connector. Then, turn the ignition key to
ON again. If the check-engine light blinks at that
time in spite of the disconnected test mode connec-
tor, carry out an engine diagnosis.
• With OBD MODEL
• Without OBD MODEL
25.STARTING CONDITION
Start the engine and check that the engine starts
smoothly. If any battery voltage problems are
found, recharge or replace the battery. If any ab-
normal noises are observed, immediately stop the
engine and check and repair the necessary compo-
nents.
26.EXHAUST SYSTEM
Listen to the exhaust noise to see if no abnormal
noises are observed.
27.INDICATOR LIGHT
Check that all the indicator lights are off.
28.CLOCK
Check the clock for normal operations and enough
accuracy.
29.RADIO
Check the radio for full functionality and normal
noise level. Also check the CD unit operations.
GI0095A
GI0119A