Subaru Impreza 2002 Service Manual page 283

CONTROL SYSTEMS
B: INSTALLATION
1) Insert the gear shift lever from room side.
NOTE:
After inserting the rod and stay, temporarily put
them onto transmission mount.
2) Mount the cushion rubber on body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
3) Move the transmission to right side, and then in-
stall the joint COMPL and stay.
Tightening torque:
T1: 11.8 N·m (1.2 kgf-m, 8.7 ft-lb)
T2: 32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A)
T1
T2
(A) Reverse check cable
4) Install the crossmember. <Ref. to 6MT-35, IN-
STALLATION, Transmission Mounting System.>
6MT GEAR SHIFT LEVER
5) Install the reverse check cable end, washer and
snap pin to reverse check lever.
NOTE:
• Take care to install the snap pin in proper direc-
tion.
• Conduct the adjustment of reverse check cable
before installation. <Ref. to CS-16, ADJUSTMENT,
Reverse Check Cable.>
TR0956
6) Install the rear exhaust pipe and muffer. <Ref. to
EX(TURBO)-13, INSTALLATION, Rear Exhaust
Pipe.>, <Ref. to EX(TURBO)-14, INSTALLATION,
Muffer.>
7) Install the under cover.
8) Install the boot plate.
NOTE:
Install the inner boot without any twist.
Tightening torque:
TR0647
9) Install the console box. <Ref. to EI-40, INSTAL-
LATION, Console box.>
10) Check that the gear shift is correctly shifted to
each gear.
CS-6
(D)
(B)
(A) Reverse check cable
(B) Washer
(C) Snap pin
(D) Front side
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
(C)
(A)
TR0957
TR0953