Subaru Impreza 2002 Service Manual page 215

MECHANICAL
32) Draw out each piston from the cylinder block
using wooden bar or hammer handle.
CAUTION:
Do not confuse the combination of piston and
cylinder.
B: INSTALLATION
(1) Crankshaft bearing
(2) Crankshaft
(3) Cylinder block
CAUTION:
Remove oil in the mating surface of bearing and
cylinder block before installation. Also apply a
coat of engine oil to the crankshaft pins.
1) Position the crankshaft on the #2 and #4 cylinder
block.
2) Apply fluid packing to the mating surface of #1
and #3 cylinder block, and position it on #2 and #4
cylinder block.
Fluid packing:
THREE BOND 1215 or equivalent
CYLINDER BLOCK
(4) Rear oil seal
CAUTION:
Do not allow fluid packing to jut into O-ring
grooves, oil passages, bearing grooves, etc.
ME(STi)-76
Tightening torque: N·m (kgf-m, ft-lb)
T1: 25 (2.5, 18.1)
T2: 47 (4.8, 34.7)
B2M2407A
S2M1826A