Subaru Impreza 2002 Service Manual page 729

PRE-DELIVERY INSPECTION
Checks with the Engine Running
Step
24. Read memory and test mode connectors
25. Starting condition
26. Exhaust system
27. Indicator light
28. Clock
29. Radio
30. Cigarette lighter
31. Lighting system
32. Window washer
33. Wiper
34. Power window operation check
Dynamic Test with the Vehicle Running
Step
35. Brake test
36. Parking brake
37. AT shift control
38. Heater & ventilation
39. Air conditioner
40. Cruise control
Checks after Dynamic Test
Step
41. ATF level
42. Power steering fluid level
43. Fluid leak check
44. Water leak check
45. Appearance check 2
PRE-DELIVERY INSPECTION
(1) Read memory and test mode connectors
(2) Start the engine and check that the engine starts smoothly.
(3) Check that the exhaust noise is normal and no leaks are found.
(4) Check that all the indicator lights operate normally.
(5) Check that the clock operates normally.
(6) Check that the radio system operates normally.
(7) Check that the cigarette lighter operates normally.
(8) Check that the lighting systems operate normally.
(9) Check that the window washer system operates normally.
(10) Check that the wiper system operates normally.
(11) Check the power window for correct operations.
(1) Check that the foot brake operates normally.
(2) Check that the parking brake operates normally.
(3) Check the AT shift patterns are correct.
(4) Check that the heater & ventilation system operates normally.
(5) Check that the air conditioner operates normally.
(6) Check that the cruise control system operates normally.
(1) Check that the ATF level is normal.
(2) Check that the power steering fluid level is normal.
(3) Check for fluid/oil leaks.
(4) Spray the vehicle with water and check for water leaks.
(5) Remove the protective coating (if any).
(6) Check the body paints for damage and smears.
(7) Check the plated parts for damage and rust.
PI-4
Check point
Check point
Check point