Subaru Impreza 2002 Service Manual page 435

CLUTCH SYSTEM
• STi model
(A) Operating cylinder
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (SUNLIGHT 2: P/N 003602010) to contact
point of the release lever and operating cylinder.
• Non-turbo model
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.5 ft-lb)
• Turbo model except STi model
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.5 ft-lb)
OPERATING CYLINDER
(A)
TR0982
B2M1179C
G2M0978
CL-6
• STi model
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T2: 41 N·m (4.2 kgf-m, 30.2 ft-lb)
NOTE:
• Be sure to install the clutch hose with the mark
side facing upward.
• Be careful not to twist the clutch hose during in-
stallation.
(A) Marking
(B) Clutch hose
(C) Operating cylinder
2) After bleeding air from the operating cylinder,
ensure that clutch operates properly.
<Ref. to CL-38, Clutch Fluid Air Bleeding.>
C: INSPECTION
1) Check the operating cylinder for damage. If op-
erating cylinder is damaged, replace it.
2) Check the operating cylinder for fluid leakage or
damage on boot. If any leakage or damage is
found, replace the operating cylinder.
T1
T2
TR0983
H2M2666B