Subaru Impreza 2002 Service Manual page 404

8) Mark an engagement point on the right and left
side retainer and clutch housing.
9) Remove the differential side retainer from both
side.
NOTE:
Note the rotating number of time till removal, when
removing the side retainer.
10) Install a new O-ring to side retainer of both
side.
11) Install the differential side retainer to both side.
NOTE:
Install the side retainer by screwing in the same ro-
tating number of time till removal, and then align
the mark.
12) Install the lock plate.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
NOTE:
Be careful not to confuse right and left lock plate.
(A)
(A) Left
(B) Right
13) Completely remove the remaining gasket from
the clutch housing and adapter plate.
FRONT DIFFERENTIAL ASSEMBLY
TR0828
(B)
TR0821
6MT-109
MANUAL TRANSMISSION AND DIFFERENTIAL
14) Apply liquid gasket to the clutch housing.
Liquid gasket:
THREE BOND 1215
15) Install the drive pinion shaft assembly. <Ref. to
6MT-101, INSTALLATION, Drive Pinion Shaft As-
sembly.>
16) Install each gear assembly at once. <Ref. to
6MT-74, INSTALLATION, Main Shaft Assembly.>
17) Install the transmission case. <Ref. to 6MT-69,
INSTALLATION, Transmission Case.>
18) Install the oil pump. <Ref. to 6MT-65, INSTAL-
LATION, Oil Pump.>
19) Install the center differential. <Ref. to 6MT-62,
INSTALLATION, Center Differential.>
20) Install the transfer driven gear. <Ref. to 6MT-
60, INSTALLATION, Transfer Driven Gear.>
21) Install the extension case. <Ref. to 6MT-49, IN-
STALLATION, Extension Case.>
22) Install the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-44,
INSTALLATION, Oil Pipe.>, <Ref. to 6MT-47, IN-
STALLATION, Neutral Position Switch.>, <Ref. to
6MT-45, INSTALLATION, Back-up Light Switch.>
23) Install the manual transmission assembly to ve-
hicle. <Ref. to 6MT-39, INSTALLATION, Manual
Transmission Assembly.>
TR0711