Propeller Shaft - Subaru Impreza 2002 Service Manual

3. Oil Seal
A: INSPECTION
Inspect for oil leakage from the oil seal. Replace
the oil seal if the lips is deformed, hardened, dam-
aged, worn or defective if any.
B: REPLACEMENT
1) Clean the transmission exterior.
2) Drain the gear oil completely.
NOTE:
• Tighten the drain plug after draining gear oil.
• Always use a new gasket.
Tightening torque:
Oil pan side
44 N·m (4.5 kgf-m, 32.5 ft-lb)
Clutch housing side
70 N·m (7.1 kgf-m, 51.6 ft-lb)
(A) Drain plug (Oil pan side)
(B) Drain plug (Clutch housing side)
3) Remove the rear exhaust pipe and muffler.
4) Remove the propeller shaft. <Ref. to DS-15, RE-
MOVAL, Propeller Shaft.>
5) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
(A) Oil seal
OIL SEAL
(A)
(B)
TR0634
B3M2135A
6MT-33
MANUAL TRANSMISSION AND DIFFERENTIAL
6) Using the ST, install the oil seal.
ST 498057300 INSTALLER
7) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
8) Install the rear exhaust pipe and muffler.
9) Pour gear oil and check the oil level. <Ref. to
6MT-32, REPLACEMENT, Transmission Gear
Oil.>
B3M1982