Subaru Impreza 2002 Service Manual page 330

5. Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the intercooler. <Ref. to IN(TURBO)-
10, REMOVAL, Intercooler.>
3) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect the ground cable from battery.
2) Jack-up the vehicle and support it with sturdy
racks.
3) Remove the center exhaust pipe. <Ref. to
EX(TURBO)-8, REMOVAL, Center Exhaust Pipe.>
4) Remove the rear exhaust pipe and muffler.
5) Remove the heat shield cover.
6) Set the transmission jack under the transmission
body.
CAUTION:
Always support the transmission case with a
transmission jack.
7) Remove the rear crossmember.
8) Remove the rear cushion rubber.
TRANSMISSION MOUNTING SYSTEM
TR0072
TR0643
6MT-35
MANUAL TRANSMISSION AND DIFFERENTIAL
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
2) Install the intercooler.
<Ref. to IN(TURBO)-11, INSTALLATION, Inter-
cooler.>
3) Connect the battery ground cable to battery.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Install the rear cushion rubber.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
2) Install the crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
3) Remove the transmission jack.
4) Install the center exhaust pipe. <Ref. to
EX(TURBO)-9, INSTALLATION, Center Exhaust
Pipe.>
5) Install the rear exhaust pipe and muffler.
TR0086
TR0648