Ford Electric Ranger 2001 Manual page 507

414-03A-104
REMOVAL AND INSTALLATION (Continued)
High Voltage/Traction Battery
2. Remove the traction battery cover.
1 Remove the 22 bolts.
2 Remove the cover.
3.
the traction battery is 312 volts. The buffer
zone must be set up and insulated rubber
gloves and a face shield must be worn.
Failure to follow these precautions may
result in severe personal injury or death.
Observe the EV-specific precautions. Refer to
Section
1 Set up the buffer zone.
2 Test and wear the insulated rubber gloves.
3 Wear the face shield.
4. Remove the fuse nut.
5. Remove the four two-pin high-voltage
connector nuts.
WARNING: The nominal voltage of
100-00.
2001 Ranger EV, 01/2001
414-03A-104