Ford Electric Ranger 2001 Manual page 235

303-03-14
REMOVAL AND INSTALLATION
Coolant Pump
Engine Cooling
Removal
1. If connected, disconnect the vehicle from the
charging station.
2. Disconnect the auxiliary battery ground cable.
CAUTION: Do not remove the radiator
3.
pressure relief cap if the coolant is hot or if
the coolant pump is running.
Turn the radiator pressure relief cap to the first
stop to remove any remaining pressure.
4. Raise and support the vehicle. Refer to
100-02.
5. Remove the LH inner fender splash shield.
Disconnect the six clips.
•
6. NOTE: When removing the water pump, it is
preferable to clamp off the coolant lines rather
than letting them drain.
Clamp off and disconnect the coolant lines from
the water pump.
303-03-14
Section
2001 Ranger EV, 01/2001