Ford Electric Ranger 2001 Manual page 158

206-07-9
REMOVAL AND INSTALLATION (Continued)
Power Brake Actuation
3. NOTE: The vacuum pressure sensor is located
in the underhood compartment underneath the
card table.
Disconnect the vacuum pressure sensor
electrical connector.
4. Disconnect the vacuum pressure sensor vacuum
lines.
5. Remove the vacuum pressure sensor.
1 Remove the bolt.
2 Remove the pressure sensor.
6. NOTE: If the vacuum tee is being replaced,
this step is not necessary. A vacuum pressure
sensor is included with the vacuum tee
replacement part.
Separate the vacuum pressure sensor from the
vacuum tee.
• Remove the two screws.
Installation
1. To install, reverse the removal procedure.
206-07-9
2001 Ranger EV, 01/2001