Table of Contents
Advertisement
Quick Links
2001 Ranger Workshop Manual
SECTION 308-03: Manual Transaxle/Transmission
REMOVAL
Transmission
Special Tool(s)
Remover, Hydraulic Line Connector
308-182 (T88T-70522-A)
CAUTION: The engine must be rotated only in the clockwise direction, otherwise engine damage can occur. The crankshaft, the crankshaft sprocket and the pulley are
fitted together by friction between the flange faces on each part. For that reason, the crankshaft sprocket can also be moved when the crankshaft pulley is turned in the
counterclockwise direction.
1. Disconnect the battery ground cable. For additional information, refer to
2. Remove the upper gearshift lever and the outer gearshift lever boot and console assembly as an assembly. For additional information, refer to
section.
3. Raise and support the vehicle. For additional information, refer to
4. If transmission disassembly is necessary, remove the drain plug, and drain the transmission fluid.
Install the drain plug after draining all of the fluid.
5. Disconnect the electrical connector from the reversing lamp switch.
6. Disconnect the following:
1. Disconnect the electrical connector from the vehicle speed sensor (VSS).
2. Disconnect the heated oxygen sensor (HO2S) electrical connector from the bracket.
7. Disconnect the wiring harness from the bracket.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS1L/~MUS~LEN/19/S...
Section
414-01.
Section
100-02.
Page 1 of 4
2001 Ranger Workshop Manual
Procedure revision date: 07/02/2003
Shift Lever and Boot
in this
8/25/2010
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ford Ranger 2001
Summary of Contents for Ford Ranger 2001
- Page 1 2001 Ranger Workshop Manual Page 1 of 4 SECTION 308-03: Manual Transaxle/Transmission 2001 Ranger Workshop Manual REMOVAL Procedure revision date: 07/02/2003 Transmission Special Tool(s) Remover, Hydraulic Line Connector 308-182 (T88T-70522-A) CAUTION: The engine must be rotated only in the clockwise direction, otherwise engine damage can occur. The crankshaft, the crankshaft sprocket and the pulley are fitted together by friction between the flange faces on each part.
- Page 2 2001 Ranger Workshop Manual Page 2 of 4 8. Disconnect the electrical connectors from the heated oxygen sensors (HO2S). 9. Remove the starter motor. For additional information, refer to Section 303-06. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its components to disconnect the yoke from the flange.
- Page 3 2001 Ranger Workshop Manual Page 3 of 4 12. Remove the bolts retaining the catalytic converter to the muffler. Discard the exhaust converter outlet gasket. 13. While supporting the exhaust inlet crossover pipe and the catalytic converter assembly, remove the exhaust hanger from the insulator. Position the exhaust assembly aside. 14.
- Page 4 2001 Ranger Workshop Manual Page 4 of 4 18. Remove the six bolts retaining the crossmember to the frame. 19. Remove the nuts and the crossmember. 20. NOTE: Lower the transmission enough to gain access to the upper bolts retaining the transmission to the engine. Remove the nine bolts retaining the transmission to the engine.
Need help?
Do you have a question about the Ranger 2001 and is the answer not in the manual?
Questions and answers