Ford Electric Ranger 2001 Manual page 546

414-03A-143
REMOVAL AND INSTALLATION (Continued)
High Voltage/Traction Battery
5.
to remove the temperature sensor or damage
to the battery module may occur.
NOTE: If the sensor is difficult to remove,
warm it using a heat gun. Be careful not to
overheat the sensor or the battery module, or
damage to both may occur.
Remove the temperature sensor.
•
Installation
1. Apply a thin coat of thermal grease to the back
of the thermistor.
2. The traction battery temperature sensors are
mounted on the side of the battery modules. To
install the temperature sensors, reverse the
removal procedure for the battery module on
which the sensor is located. Refer to the
appropriate Traction Battery Module procedure.
CAUTION: Do not use excessive force
Pull the bottom of the temperature sensor
from the battery module and remove the
sensor.
2001 Ranger EV, 01/2001
414-03A-143