414-03B-121
REMOVAL AND INSTALLATION (Continued)
Traction Battery Charger
High Voltage/Traction Battery — Nickel Metal Hydride
5. NOTE: The RH front bolt must be installed
first in order to correctly align the battery pack.
Install the battery pack mounting bolts.
Apply Locktite 242 to the bolts prior to
•
installation.
Install the LH front bolt first in order to
•
properly locate the battery pack.
6. Lower the lift table and disconnect the shop air
source.
7. Raise the vehicle and roll the lift table from
under the vehicle.
8. NOTE: The bolt will break if the specified
torque is exceeded. If this happens, pull the
connector off the bolt stem and remove the
broken bolt.
Connect the 76-pin connector and tighten the
bolt.
9. Connect the traction battery auxiliary load
high-voltage connector. Refer to
100-05.
10. Connect the traction battery two-pin
high-voltage connector. Refer to
100-05.
Removal
1. Remove the high-voltage power distribution box
(HVPDB). Refer to
High Voltage Power
Distribution Box
(HVPDB).
414-03B-121
Section
Section
2001 Ranger EV, 01/2001