204-02-22
REMOVAL AND INSTALLATION (Continued)
Rear Suspension
14. With the 15 mm socket still in place, pull the
shim back as far as possible.
15. Verify that the spring clamp plate is contacting
the hub assembly. If the two surfaces do not
contact each other, replace the steel spacer with
a thinner shim (four available).
16. Using the special tool, align the spring clamp
plate, spring, and hub assembly.
• Tighten the bolt until the edges of the spring
clamp plate and the hub assembly are
parallel.
17. Tighten the bolts.
204-02-22
2001 Ranger EV, 01/2001