414-03B-95
REMOVAL AND INSTALLATION (Continued)
High Voltage/Traction Battery — Nickel Metal Hydride
5. Disconnect the low voltage connector.
1 Loosen the bolts.
2 Disconnect the connectors.
6. Remove the battery control module (BCM).
1 Remove the bolts.
2 Remove the BCM.
Installation
CAUTION: Do not overtighten the
1.
BCM multi-pin connectors. Damage to the
connectors may occur if overtightened.
To install, reverse the removal procedure.
Apply Locktite 242 to the 22 traction
•
battery cover bolts.
After installation, connect the New
•
Generation STAR (NGS). Turn the ignition
key ON. Enter the battery control module
(BCM) active command mode RESET
HISTORICAL DATA and set the active
command RESET to ALL.
Remove the NGS and charge the traction
•
battery. Refer to
414-03B-95
Section
100-05.
2001 Ranger EV, 01/2001