Ford Electric Ranger 2001 Manual page 684

414-03B-81
GENERAL PROCEDURES (Continued)
Special Tool(s)
Traction Battery High-Voltage
Service Cord
418-F218
Traction Battery Low-Voltage
Service Cord
418-F219
High Voltage/Traction Battery — Nickel Metal Hydride
Module Replacement
1. If necessary, charge all new replacement battery
modules prior to installation. Refer to Module
Charging to determine battery module charging
conditions.
2. With the key ON, enter battery control module
(BCM) active command mode RESET
HISTORICAL DATA and set the active
command RESET to the battery module(s) that
were replaced.
3. NOTE: If more than two battery modules need
to be replaced, do not replace the traction
battery cover or install the traction battery at
the end of the procedure. Repeat the battery
module removal and installation process until
all battery modules have been replaced. Only
two battery modules can be replaced at a time,
as there are only two In-Line Bypass Battery
Modules in the special service tool kit.
NOTE: Position the vehicle near a charging
station before beginning the procedure.
Remove the traction battery. Refer to Traction
Battery.
414-03B-81
2001 Ranger EV, 01/2001