Ford Electric Ranger 2001 Manual page 346

412-03-14
REMOVAL AND INSTALLATION (Continued)
Air Conditioning
9. NOTE: If the isometric bracket for the
compressor is excessively deteriorated, replace
it during compressor removal and installation.
Remove the four A/C compressor bolts.
10. Lower the vehicle.
11. Remove the A/C compressor.
Carefully feed the compressor electrical wire
•
down with the compressor.
Installation
CAUTION: The compressor uses
1.
Polyolester oil meeting Ford specification
WSS-M2C31-B. This oil is not compatible
with any other A/C oil.
If the service compressor has no warning
tag/label, then it has a full production (system)
charge of oil (170 cc) and the following steps
must be followed.
1 Flush the A/C system to remove all existing
oil.
2 Replace the accumulator.
3 Install the compressor.
2. If the service compressor has a warning
tag/label, then it has no oil charge and 30 cc of
Polyolester oil meeting Ford specification
WSS-M2C31-B must be added to the system
after compressor installation.
CAUTION: Do not add any leak
3.
detection dye to the A/C system.
To install, reverse the removal procedure.
412-03-14
2001 Ranger EV, 01/2001