Ford Electric Ranger 2001 Manual page 504

414-03A-101
REMOVAL AND INSTALLATION (Continued)
Charge Inlet
High Voltage/Traction Battery
Removal
1. NOTE: For Electric Ranger Only.
Disconnect the traction battery auxiliary load
high-voltage connector. Refer to
100-05.
2. Remove the grille.
1 Remove the four screws.
2 Remove the grille.
3. NOTE: The low-voltage connector is located at
the rear of the charger inlet.
Disconnect the low-voltage electrical connector.
4. Disconnect the traction battery charger
high-voltage electrical connector.
•
Unclip the four wiring harness clips.
2001 Ranger EV, 01/2001
414-03A-101
Section