Ford Electric Ranger 2001 Manual page 579

414-03A-176
DISASSEMBLY AND ASSEMBLY (Continued)
High Voltage/Traction Battery
NOTE: The temperature sensor harness feeds up
through the space between the separators.
NOTE: The HVJ wiring that runs between the
battery modules must fit into the separators.
28. Install the front separator plates.
29. NOTE: The rear separator can be identified by
the velcro strips on the right-hand side. These
strips are for holding the contactor box in
position.
Install the rear separator plates.
30. Use a heat gun to warm the temperature sensor
prior to installation.
31. Apply a thin coat of thermal grease to the back
of the thermistor.
32.
to install the temperature sensor, or damage
to the module may occur.
Install a temperature sensor on the - (negative)
terminal side of battery modules 16 and 17.
1 Position the temperature sensor prongs into
2 Clip the temperature sensor into the pin on
CAUTION: Do not use excessive force
the holes in the battery module.
the battery module.
2001 Ranger EV, 01/2001
414-03A-176