Control Commands [Command Edit] - IDK MSD-5401 User Manual

8.12.1 Control commands [COMMAND EDIT]

You can register up to 32 commands.
Item
Select "COM", "Tally", or "CEC".
PORT
Set the waiting time of the control command. Use this
DELAY item for devices such as projectors that requires time
to cool down after powering off.
Set the following communication ports to "OFF" (not
sending communication commands) or "ON" (sending
communication commands). Those ports can be set
separately, and communication commands can be
Communication sent to multiple communication ports at the same
*1
port time.
RS1: RS-232C CH1
RS2: RS-232C CH2
LOOP BACK: Internal loop back
LAN1 to LAN8: LAN connections 1 to 8
Set the number of bytes to be sent starting with the
*1
COM SIZE
first byte.
Set the input mode of send command data. Select
"ASCII" if "DATA" of "COMMAND" consists of only 0A,
COMMAND
*1
0D, and 20 to 7D of "9 ASCII codes"; select "HEX" if
INPUT MODE
"DATA" of "COMMAND" includes other codes.
Send command Set the command from the first byte according to the
*1
number of bytes set in "COM SIEZE" (up to 30 bytes).
data
RECV DISPLAY
Set whether received data is displayed or not.
*1
[Table 8.13] Setting items of control commands
Description
*6
*6
*7
159
Range
COM: Communication
command [Default]
Tally:Tally output
CEC: HDMI CEC
0 ms. to 999 seconds and 999
ms.
[Default]: 0 ms.
OFF [Default]
ON
0 byte to 30 bytes
[Default]: 0 byte
ASCII [Default]
HEX
0A, 0D, 20 to 7D of "9 ASCII
codes" (If inputting with ASCII
codes), or 00 to FF of hex (If
inputting with hex)
[Default]: 20 (Space)
(All numbers above are hex)
OFF [Default]
ASCII
HEX