Output Masking [Output Masking] - IDK MSD-5401 User Manual

8.3.12 Output masking [OUTPUT MASKING]

You can hide unnecessary part (top/bottom and right/left) by setting masking.
You can set masking for each input by following the "8.3.8 Input masking" menu or for each output using this
menu. Normally, set masking of each input in the settings of each input. If you want to limit the display area on
the output screen, set the masking for each output.
▪ Left side masking: Masked in a unit of pixel [Default]: 0
▪ Right side masking: Masked in a unit of pixel [Default]: Horizontal output resolution
▪ Top side masking: Masked in a unit of line [Default]: 0
▪ Bottom side masking: Masked in a unit of line [Default]: Vertical output resolution
( 0, 0 )
Left
masking
The range of set values depends on settings of "8.3.1 Output resolutions", "8.3.10 Output position", "8.3.11
Output size" and masking. If you change the output resolution, position or size, the display range before that
change is kept and the settings of masking are automatically changed. Default values (no masking) of the left
and top sides are 0 while that of the right and bottom sides are the input size.
Top masking
Bottom masking
[Figure 8.25] Output masking
Right
masking
( Horizontal size, Vertical size)
68
MSD-54 SERIES User's Guide
For each output