7.5 Loading Cross Point
You can register up to nine cross points in the MSD, but the MSD can only load cross points 1 to 5 by cross
point load keys. To load cross points 6 to 9, use menu settings in the "Load cross point" section ("8.13.1
Loading cross point") or use RS-232C, LAN, or parallel inputs.
Since nothing is registered by factory default, cross point is not valid until they are registered. To load them,
register cross points in advance.
Command control:
▪ Loading V&A input selection setting from cross point memory: @RCM
▪ Loading video input selection setting from cross point memory: @RCV
▪ Loading audio input selection setting from cross point memory: @RCA
To load cross point settings:
■ Procedure
Select "PRESET LOAD" using the Operation Mode selection key.
1
Press the cross point command keys to load the cross point settings.
2
Commands A to E correspond to cross points 1 to 5.
DIGITAL
DISPLAY
POWER
MULTI
SWITCHER
1
2
POWER
3
ON
OFF
4
7.6 Locking/Unlocking Front keys
To lock the front panel keys, press and hold the Operation Mode selection key for 2 seconds or longer until
hearing the buzzer sound. To release the key lock, do the same operation again. When the setting is changed,
the status will be displayed for 1 second.
KEY LOCK !
Locked
Command control: Setting and releasing key lock: @SLS/@GLS
IN1
IN2
IN3
IN4
IN5
[Figure 7.5] Loading cross points
KEY LOCK RELEASE !
Unlocked
IN6
IN7
IN8
IN9
OFF
Operation mode
selection keys
28
MSD-54 SERIES User's Guide
OUT1
COMMAND
COMMAND
COMMAND
COMMAND
A
B
C
D
OUT2
OUT3
MENU/SET
COMMAND
PRESET LOAD
OUT4
ESC
SWITCHING MODE
V&A
VIDEO
AUDIO
Cross point load key
MSD-5404
COMMAND
E