IDK MSD-5401 User Manual page 48

[If edges are cut off due to enlargement in the display device side]
If video is input to a wide TV or the like, the video is automatically enlarged and displayed, and sometimes
edges are cut off. In this case, change the display size (such as "Full display", "Wide display"). If the problem
is still not resolved, set "8.3.10 Output position" and "8.3.11 Output size".
To set output position and size:
■ Steps
Select "OUTPUT FRAME" in "8.3.15 Test pattern".
1
Set the display position by following "8.3.10 Output position" to match the upper left of the display
2
device and test pattern.
Reduce the test pattern by following "8.3.11 Output size" to match the lower right of the display device
3
and the test pattern.
Set the test pattern to "OFF".
4
Test pattern
[Figure 8.13] Setting position, size, and masking of output side
Edges of the top, bottom,
right, and left are cut off
due to enlarged display in
the display device side.
48
MSD-54 SERIES User's Guide
Match the upper left of the
test pattern with the upper
left of the display device.
Match the upper right of the
test pattern with the upper
right of the display device.