IDK MSD-5401 User Manual page 162

[Step I. When setting "PORT" to "COM"]
PORT:COM SIZE: 0BYTE
DELAY: 0s000ms
↓◄►keys
PORT:COM SIZE: 0BYTE
DELAY: 0s000ms
↓◄►keys
PORT:COM SIZE: 0BYTE
DELAY: 0s000ms
↓◄►keys
RS1:OFF RS2:OFF
LOOP BACK:OFF
↓◄►keys
LAN1:OFF LAN2:OFF
LAN3:OFF LAN4:OFF
↓◄►keys
LAN5:OFF LAN6:OFF
LAN7:OFF LAN8:OFF
↓◄►keys
COMMAND INPUT MODE:
ASCII
↓◄►keys
After this step, procedures to input send command data differ depending on settings of the "COMMAND
INPUT MODE". Go to I-i or I-ii below to continue.
*1
The command size can be set also when inputting the command data.
If you press the "SET" key for 1 second or longer on the command data input screen, the number of data up
to the current cursor position will be set as the size of the command data. For example, when pressing
the "SET" key for one second or longer while the following display is displayed, up to the 5
the data size.
▲▼keys: Set the size of send command data (1 to 30).
If not registered, "0" is displayed.
▲▼keys: Set the delay time in seconds (0 to 999).
▲▼keys: Set the delay time in milliseconds (0 to 999).
▲▼keys: Select the RS port to send commands (OFF, ON).
◄►keys: Moves the cursorto the next communication port.
▲▼keys: Select the LAN port (1 to 4) to send commands (OFF, ON).
◄►keys: Moves the cursorto the next communication port.
▲▼keys: Select LAN the ports (5 to 8) to send commands (OFF, ON).
◄►keys: Moves the cursorto the next communication port.
▲▼keys: Select the desired command input mode (ASCII, HEX).
DATA:INPUT
5:
*1
DATA:49 4E 50 55 54
5:20 20 20 20 20
162
MSD-54 SERIES User's Guide
th
byte is set as