IDK MSD-5401 User Manual page 172

Note:
If the MSD sends a communication command back to the MSD itself using the loop back function, the MSD
replies "OK" if processed normally while it replies "NG" if parameter or command is incorrect. (This differs
from reply commands to communication commands received externally; not loop back.) Since "OK" and "NG"
are registered to reply commands 31 and 32 by factory default, respectively, do not edit or delete those
commands if you use the loop back function and check reply commands.
1. To edit the reply command using menu:
MSD-5404
↓ SET key
[FUNCTION SELECT]
PRESET COMMAND
↓ SET key
[PRESET COMMAND]
RECV COMMAND EDIT
↓ SET key
[RECV COMMAND EDIT]
CMD 1
↓ SET key
SIZE: 0BYTE
PROCESS:EXEC
↓◄►keys
SIZE: 0BYTE
PROCESS:EXEC
↓◄►keys
PJLink:OFF
↓◄►keys
COMMAND INPUT MODE:
ASCII
↓◄►keys
Procedures to input send command data differ depending on settings of "COMMAND INPUT MODE" (Go to
steps I-I or I-ii below)
SIZE PROCESS
1 0 byte EXEC
2 0 byte EXEC
3 0 byte EXEC
4 0 byte EXEC
5 0 byte EXEC
32
30 0 byte EXEC
31 2 bytes EXEC
32 2 bytes STOP
[Figure 8.52] Defaults of reply commands
Top
▲▼keys: Select "PRESET COMMAND".
▲▼keys: Select "RECV COMMAND EDIT".
▲▼keys: Select the reply command (CMD 1 to CMD 32).
Memo is displayed on the right of the command number.
↑ ESC key: Cancels the setting and returns the menu.
▲▼keys: Set the size of reply command data (0 to 30).
If not registered, "0" is displayed.
▲▼keys: Select the mode for when retry over occurs (STOP, EXEC,
RETRY).
▲▼keys: Set whether setting PJLink commands (OFF, ON).
▲▼keys: Set "COMMAND INPUT MODE".
(ASCII, HEX)
DATA MASK MEMO
All 00 All FF All space
All 00 All FF All space
All 00 All FF All space
All 00 All FF All space
All 00 All FF All space
All 00 All FF All space
OK All FF
NG All FF
172
MSD-54 SERIES User's Guide
OK
NG