IDK MSD-5401 User Manual page 216

■MSD-5403
[Table 8.31] Factory default of Tally output connectors of MSD-5403
Pin No. Description
1
2 OUT1-IN1
3 OUT1-IN2
4 OUT1-IN3
5 OUT1-IN4
6 OUT1-IN5
7 OUT1-IN6
8 OUT1-IN7
9 OUT1-IN8
10 OUT1-IN9
11 OUT1-OFF
12 OUT2-IN1
13 OUT2-IN2
14 OUT2-IN3
15 OUT2-IN4
16 OUT2-IN5
17 OUT2-IN6
18 OUT2-IN7
19 OUT2-IN8
20 OUT2-IN9
21 OUT2-OFF
22 OUT3-IN1
23 OUT3-IN2
24 OUT3-IN3
25
*1
Pins for the currently selected channels are pulled to ground, allowing current to flow through them.
Output target of video and audio depends on channel switching mode. (If video and audio channels are not
the same and "V&A" is selected for channel switching mode, the video channel is output.)
*2
Pins for the switching mode channels currently selected in parallel are pulled to ground.
*3
Control commands that are registered in COMMANDs A to I are pulled to ground. However, each command
execution condition (COMMAND A to I) has two planes (PLANE A and PLANE B). If control commands are
registered in both planes, the control commands are executed alternately every time parallel input of
COMMAND A to I is turned ON/OFF. If PLANE A is set to be executed at the next parallel input ON, it is
pulled to ground (lights); if PLANE B is set to be executed at the next parallel input ON, ground is set
ON/OFF alternately (blinks).
Ground can only be output when the control command is executed according to the setting of "8.12.7
Command key setting". Ground is set ON/OFF alternately (blinks) when control commands are executed
according to the setting of "8.12.8 Flash time (Command keys and DISPLAY POWER keys)".
*4
Pins are pulled to ground when the MSD is turned on.
*5
Pin is pulled to ground while parallel input is locked.
Function
+5V
Selecting input
channel of OUT
*1
1
Selecting input
channel of OUT
*1
2
Selecting input
channel of OUT
*1
3
GND
216
MSD-54 SERIES User's Guide
Pin No. Description
26
27 OUT3-IN4
28 OUT3-IN5
29 OUT3-IN6
30 OUT3-IN7
31 OUT3-IN8
32 OUT3-IN9
33 OUT3-OFF
34 SWITCHING–V&A
35 SWITCHING–VIDEO
36 SWITCHING–AUDIO
37 COMMAND A
38 COMMAND B
39 COMMAND C
40 COMMAND D
41 COMMAND E
42 COMMAND F
43 COMMAND G
44 COMMAND H
45 COMMAND I
DISPLAY1 POWER
46
ON
DISPLAY2 POWER
47
ON
DISPLAY3 POWER
48
ON
49 PARALLEL LOCK
50
Function
+5V
Selecting input
channel of OUT
*1
3
Selecting
channel
switching mode
*2
Sending control
*3
commands
Controlling
display power of
*4
OUT 1
Controlling
display power of
*4
OUT 2
Controlling
display power of
*4
OUT 1
Controlling
display power of
*5
OUT 2
GND