IDK MSD-5401 User Manual page 252

[Error codes]
Displaying for each output connector: the output statuses of video and audio are
displayed on the lower right. The status characters are shown from the left to the
right, the statuses of video output to HDMI output connector, audio output to HDMI
output connector, and audio output to the analog audio output connector are displayed. The status of HDMI
output connector is displayed only if a display device is connected. If video or audio cannot be output, an error
code number or alphabet character is displayed.
Status
If any number or "A" is not displayed, video or audio is output correctly.
－
1
Displayed only for IN1 to IN5. DDC power supply is not input. (If no input device is connected, this
2
status is displayed.)
3 No video signal is input.
4 Displayed only for IN1 to IN5. Video or audio output of source device is in a Mute status.
Displayed only for IN1 to IN5. Signals with HDCP are input, but the display device does not support
5
HDCP. (This may also be displayed while authenticating HDCP.)
Displayed only for IN1 to IN5. The source device does not output required information (packets) for
6
outputting video or audio.
Signals that are not supported by the MSD are
7
input. (Sampling clock is out of the range.)
－
8
－
9
Input is set to "OFF".
A
*1
Input status of analog audio signals cannot be detected. Even if this status is not displayed, audio may
sometimes not be output when analog input is selected.
*2
This status is only for HDMI output connectors.
2. To display status of display device using commands:
@GSS: Get I/O status
[Table 8.38] Output status
Video output
"8.8.2 Output mute" is set to "ON".
No audio signal is input
Audio cannot be output, because
compressed audio is input. (Compressed
audio can be output only to display devices
supporting compressed audio.)
"8.8.8 Output connector" is set to "OFF".
"8.7.2 Output mode" is set to "DVI MODE" or
a display device that does not support audio
is connected.
252
MSD-54 SERIES User's Guide
[OUT1 MONITOR] H30
HDCP SUPPORT
Audio output
*1
*2
333