Output Settings; Output Equalizer [Output Equalizer] - IDK MSD-5401 User Manual

8.7 Output Settings

8.7.1 Output equalizer [OUTPUT EQUALIZER]

HDMI input connector has an equalizer circuit to correct attenuated signals caused when a long cable is
connected. Set the output equalizer according to the cable length.
･No correction: OFF [Default]
･Modest correction: LOW
･Middle correction: MIDDLE
･Significant correction: HIGH
[Table 8.2] Output equalizer
Cable length Shorter than 32.8 ft./10 m 32.8 ft./10 m or longer
Setting
If you use other manufacturers' cable, use this table only as a reference.
If a display device that is in a significantly bad condition is connected, the video may be distorted.
[Table 8.3] Amount of corrections
Setting of output
equalizer
OFF
LOW
MIDDLE
HIGH
1. To set the output equalizer using menu:
MSD-5404
↓ SET key
[FUNCTION SELECT]
OUTPUT SETTING
↓ SET key
[OUTPUT SETTING]
OUTPUT EQUALIZER
↓ SET key
[OUT1 EQUALIZER]
OFF
↓ ESC key: Returns to the previous screen.
2. To set the output equalizer using commands:
@SEQ: Set output equalizer
@GEQ: Get output equalizer
"OFF" to "MIDDLE"
Amount of
corrections
0.0 dB
1.5 dB
3.5 dB
6.0 dB
Top
▲▼keys: Select "OUTPUT SETTING".
▲▼keys: Select "OUTPUT EQUALIZER".
▲▼keys: Select the desired output equalizer mode (OFF, LOW,
◄►keys: Select the desired output (OUT1 to OUT4).
"LOW" to "HIGH"
MIDDLE, or HIGH).
107
For each output