Loading Device Data [Load] - IDK MSD-5401 User Manual

8.6.9 Loading device data [LOAD]

For digital input (IN1 to IN 5): Settings of input timing will be initialized to settings that are detected
automatically by MSD. Use this menu to restore the input timing settings that are set manually to the original
timing.
For analog input (IN6 to IN9): Registered device data will be loaded. Use this menu in the following cases:
● Several device data with the same frequency of synchronous signal and different input timings is
registered
● You want to set the input timing again.
1. To load the device data using menu:
MSD-5404
↓ SET key
[FUNCTION SELECT]
INPUT TIMING
↓ SET key
[INPUT TIMING]
LOAD
↓ SET key
[For digital input]
[IN1 LOAD]
1920x1080
[For analog input]
[IN6 LOAD]
No. 1
↓ SET key: Loads settings
[PRESET TABLE 1]
NOW LOADING...
↓
[INPUT TIMING]
LOAD
* Only table numbers that can be loaded are displayed. If only numbers (1 to 99) are displayed, those
numbers show the device data registered in "8.6.10 Registering device data", and the registered name is
displayed on the right. "P+Number" shows pre-registered device data, and the resolution is displayed on
the right.
Top
▲▼keys: Select "INPUT TIMING".
▲▼keys: Select "LOAD".
↑ ESC key: Returns to the previous screen without loading the setting.
◄►keys: Select the desired input (IN1 to IN9).
▲▼keys: Select the desired table number.*
◄►keys: Select the desired input (IN1 to IN9).
Displays the message for 1 second before automatically returning to
the previous screen.
103
For each input port/input signal